opkicloud.blogg.se - Parametric modeling with autodesk inventor 2015

Many of the drawing enhancements that were introduced in the Autodesk Inventor 2015 software do not impact new users, but in some cases notes were added in the margins and in the body of the material to explain the enhancements.

These options are covered and are used in the practice. However, one convenient enhancement was introduced to Joint Connections, which enables you to create a green joint origin between faces and offset from a selected origin.

There were not any major functionality changes in the Assembly environment.

The sweep material in the training guide now covers how Twist can be added to sweep geometry.

The ability to automatically remove edges from a fillet selection set if the radius value is not acceptable has been updated in the training guide.

The Offset command functionality also covers how as entities are now automatically removed from the offset selection set as they dragged to a zero length.

The new Constraint Settings dialog box, which contains all of the settings in one convenient location is also discussed.

Relax Mode is covered and is covered in a practice. Images have been updated to reflect the new constraint symbols.

The changes to constraints are discussed throughout the training guide.

Students are asked to project edges as needed. All of the materials in the training guide have been updated to reflect this.

Edges that lie on a sketch plane are no longer projected by default.

In the Loft and Mirror material new practices have also been added to replace the older ones.

The Primitive Base Feature topic and its practice have been moved to an Appendix.

This new single practice combines the three that were in the training guide.

A new practice has replaced the practices in Chapter 1.

The majority of these involve images of the Ribbon in the 3D Model and Sketch tabs.

Images have been updated in the training guide as needed to reflect the software changes.

It’s discussed and used throughout the training guide.

There is a new My Home tab, which can be used to create new files, activate project files, and access recently used files.

General Interface Enhancements and Training Guide Changes In this post I am going to focus on the Autodesk® Inventor® 2015 Introduction to Solid Modelingand Autodesk® Inventor® 2015 Update for 2013/2014 Users training guides.Īutodesk Inventor 2015 Introduction to Solid Modeling Similar to last year, I will divide the information over a few blog posts covering the titles that have released so far.

Once again it’s the time of year when I share with you how the 2015 Autodesk Inventor curriculum has changed.